Instrument Panels ~ Final Finishing

Back side of cured part for side panels.

Vacuum bagging of the instrument side panel material was a success however the part compressed more than we thought it would so we didn't achieve the desired thickness necessary to surface match to the center panel.  That's ok.  A small lip down from the center panel to the side panels still works. One would think 8 layers of cloth would make for a thick part.  Eight hours of -28InHg vacuum really bleeds all excess resin resulting in a very nice 50:50 fabric to resin ratio for the part.

Left and right side panels were cut to exactly match the aluminum back plate.  This required a lot of careful cut, fit, sand, repeat.  The holes for the AOA, ELT, and side vents will be cut after clear coating.

After a great deal of measuring and cutting, the assembled panels created a nice fit with a tight adjoining seam. The panels are ready for clear coat

Center and side panels were scuff and cleaned.  Wax & Grease remover was used as a final cleaner to ensure that all contaminants were removed prior to painting.

Master painter, John Branchaw, carefully applied four layers of clear coat to each panel.

Finished carbon fiber panel.

Clear coating gave the panels a rich finish with great contrast.  The TeXtreme 1000  2.95oz uni-directional tapes created a very nice checkered pattern.  A few easy cuts for the AOA, ELT, and air vents and the panels were finished.  Overall, a great finish to a fun project.  Many thanks to John Branchaw for prep and paint work!

Next step, mount the avionics trays and install the avionics.